Settings for new DLink router?

[probedb]

Hi folks,

I've followed all the guides but can't get my 2740R to connect. I have the following options set :

Dynamic IP Address Choose this option if your ISP uses Dynamic IP Address over DSL.
Connection Type : 1483 Bridged IP LLC (other opt is same but VC-Mux)
MAC Address : : : : : : all zeros

NAT : Enable
IGMP : Disable
Default Route : Enable
VPI : 0
VCI : 101
Virtual Circuit : Enable
Service Category : CBR (opts are CBR, UBR, rtVBR, nrtVBR)
PCR : 0 cells/second
SCR : 0 cells/second
MBS : 0 cells

Any ideas?

I'm disconnecting and having a play now but any help appreciated

Cheers!
Paul.

[probedb]

Sorted....

[neilmcl]

Care to share what you did to help others.

[probedb]

Originally Posted by neilmcl

Care to share what you did to help others.

I was just being stupid. I used the settings on here and left the rest as standard. I'd just expected it to connect as soon as I hit save and the page refreshed but that's not how it worked, went to another page in the admin console and noticed the 'Connected' bit had lit up in the console